|STUD SIZE||.105" insulation pin through 5/32 whit or M4 threaded studs|
|STUD MATERIAL||Mild steel, stainless steel. Zinc, galvanised and copper finished.|
|SIZE(L.W.H)||315 mm x 436 mm x 245 mm|
|WELDING RATE||15 per minute|
|INPUT POWER||240V A.C.|
Output voltage; circuit breaker operator protection.
Gun 4.8m (16')
Earth 3.04m (10')
Designed specifically for the insulation industry
The CD1000 is designed specifically for the insulation industry. The Pin
Welders robust and reliable design has performed efficiently and reliably for
many years under the stress of on-site and workshop conditions.
The unique chuck guard design has the following advantages:
- No adjustment necessary for different length pins.
- Protects chuck from zinc splashing during welding, therefore increasing the life of the chuck.
- Because of the self-tightening effect between the chuck and the chuck guard, arcing between the chuck and the pin is kept to a minimum.
|SPEED OF OPERATION||Welding time is less than 0.0002 seconds. Fifteen welds per minute possible.|
|COST SAVING||Speed of operation and portability cut costs up to 10 times compared with conventional methods, drilling tapping etc. Material saving by virtue of simpler design.|
|RELIABILITY||Robust construction and solid state components insure long life and dependability in harsh working environment.|
|NO REVERSE SIDE MARKING||No distortion or burning. Therefore no reworking on the reverse side.|
|SIMPLE TO OPERATE||Unskilled operators are all that is needed. No flux, ferrules or inert gas required.|
|SAFE||No arc flash. Fully insulated gun, 14V DC operation. Internal safety circuit to protect operator.|
ABN 38 108 395 027
96a Herald Street
Telephone: 03 9584 1588
International: +61 3 9584 1588
Hours: 8am-4.30pm Monday to Friday